"TOWARDS SUSTAINABLE FUTURE"
XP-Q1200/IP
Advanced Search
Search the Knowledgebase
Category
Q Series Controller – XP-Q1200/IP
1 Door IP Access Controller
- Support QR Code
- Encrypted IP
- Direct TCP/IP
- High Capacity
- Supports Up to 16 Digits
FeaturesConfiguration DiagramDocumentationFAQ
| No | Item | Features |
| 1. | No. of Doors | 1 Doors |
| 2. | No. of Readers | Max 2 Readers (Plato Readers) – 1 Entry / 1 Exit |
| 3. | Wiegand / ABA Reader | Yes – Max 2 |
| 4. | Connection to PC | IP LAN (10/100 Base-T) / RS485 (Optional) |
| 5. | Connection to Readers | RS485 – Plato Reader Series / Wiegand / ABA |
| 6. | Card Holders | 30,000 (16 Digits) |
| 7. | Transactions | 50,000 |
| 8. | Time Setting | 255 Time Sets / 255 Time Zone (No Access Level Limits) |
| 9. | Holiday | 30 (2 sets) |
| 10. | Inputs | 1 x Door Sensor, 1 x Exit Button, 1 x Dedicated Fire Alarm Input, 1 x Dedicated Tamper Input, 2 x Sensor Inputs |
| 11. | Door Relay Output(s) | 1 |
| 12. | Extra Relay Output(s) | Yes (1) – Configurable |
| 13. | Encrypted IP | Yes. AES 128 |
| 14. | Global Anti-Passback | Yes – with SNET-GAC |
| 15. | Real Time Clock | Yes – with On Board Battery |
| 16. | Power Fail Monitor | Yes – with Power Level Monitoring |
| 17. | Firmware Upgrade | Download from Software |
| 18. | Diagnostic | Yes – Using Built in Web Browser |
| 19. | Onboard LED Indicator | Yes – Main Fail, Run, Coldstart, RS485 Readers Connected Status, Downlink RS485 Reader Comm. (RX & TX), UplinkSerial to Software (TX & RX), Fire Alarm, Door Sensor, Push Button, Sensor Inputs, Relay Outputs |
| 20. | Onboard Buzzer | Yes |
| 21. | Use with other MicroEngine controllers | Yes |
| 22. | Processor | Microchip PIC32 – 32 bit RISC MCU at 80 MHz |
| 23. | Memory | Program (FLASH: 512kB); DATA (EEPROM: 128KB, FLASH |
| 24. | PCB Board Dimension | 160mm (L) x 79.8mm (W) |
| 25 | Casing Dimension | 310mm (H) x 267mm (W) x 72mm (D) |
| 26. | Power Consumption | Typically 150mA (12VDC) |
| No | Documentation |
| 1. |  DATASHEET-2025_XP-Q1200-IP |
FAQ
1. I have purchased XP-M1300i and I need to…
- To install the controller, follow the wiring connection diagram provided, see article ID: AA-00363
- To configure the uplink connection, see article ID: AA-00206 if using a network connection, or see article ID: AA-00319 if using an RS485 connection
2. I have installed XP-M2300i at my site, but how do I configure the controller?
- To reset the controller to factory default setting (Coldstart), see article ID: AA-00303
- How to use Auto PIN only to access the door, see article ID: AA-00204
- How can I use Card+Pin Mode, see article ID: AA-00325